作者saap (saap)
看板comm_and_RF
標題Re: [問題] 802.16的QoS表
時間Tue Jun 13 14:39:17 2006
感謝先進的回覆,
之前就有收到先進的來信回覆但因想找到最佳解答再回覆,
因此無立即有動作...抱歉;
先進在文中提到有提到802.16的QoS有三種等級,
Provision QoS Parameter Set、Admitted Qos Parameter Set、
Active QoS Parameter Set,
然而規格書中提到Provision QoS Parameter Set不屬於本規格書討論中,
但它有提到此參數集屬於Network Management System,
因此可以知道此參數屬於802.16f規格書中定義,
只有Admitted QoS Parameter Set與Active QoS Parameter Set由BS管理,
然而小弟不明白的地方是規格書中提到此兩種參數,
但卻未提到說這兩種參數到底是個別紀錄,
或者是說只有一組參數再藉由狀態欄來判別目前此參數是Admitted or Active,
小弟想明瞭的是這一點,
謝謝。
※ 引述《csmao (Creeping Death)》之銘言:
: ※ 引述《saap (saap)》之銘言:
: : 請教各位網友,
: : 在802.16-2004 Std中提到某一service flow的AdmittedQosParaSet有值,
: : 但ActiveQoSParaSet設為0,
: : 因此小弟認為在BS中有兩個Table分別存放這兩種Qos的參數,
: : 但是文中卻又未明確提到其有兩種表,
: : 因此想請教這兩種Qos參數到底是怎麼回事呢?
: Actually, there are three classes of QoS parameters, i.e.,
: Provisioned, Admitted and Active.
: The AdmittedQoSParaSet means that the set is only admitted but
: not activated by the BS. On the contrally, the ActiveQoSParaSet
: shall be admitted first(not for Provisioned), then the set can be
: activated. Therefore, in your context, the situation that
: ActiveQoSParaSet is set to zero means this parameter set is only
: admitted.
: Hope the above is helpful for you!
--
※ 發信站: 批踢踢實業坊(ptt.cc)
◆ From: 140.138.238.95