作者saap (saap)
看板comm_and_RF
标题Re: [问题] 802.16的QoS表
时间Tue Jun 13 14:39:17 2006
感谢先进的回覆,
之前就有收到先进的来信回覆但因想找到最佳解答再回覆,
因此无立即有动作...抱歉;
先进在文中提到有提到802.16的QoS有三种等级,
Provision QoS Parameter Set、Admitted Qos Parameter Set、
Active QoS Parameter Set,
然而规格书中提到Provision QoS Parameter Set不属於本规格书讨论中,
但它有提到此参数集属於Network Management System,
因此可以知道此参数属於802.16f规格书中定义,
只有Admitted QoS Parameter Set与Active QoS Parameter Set由BS管理,
然而小弟不明白的地方是规格书中提到此两种参数,
但却未提到说这两种参数到底是个别纪录,
或者是说只有一组参数再藉由状态栏来判别目前此参数是Admitted or Active,
小弟想明了的是这一点,
谢谢。
※ 引述《csmao (Creeping Death)》之铭言:
: ※ 引述《saap (saap)》之铭言:
: : 请教各位网友,
: : 在802.16-2004 Std中提到某一service flow的AdmittedQosParaSet有值,
: : 但ActiveQoSParaSet设为0,
: : 因此小弟认为在BS中有两个Table分别存放这两种Qos的参数,
: : 但是文中却又未明确提到其有两种表,
: : 因此想请教这两种Qos参数到底是怎麽回事呢?
: Actually, there are three classes of QoS parameters, i.e.,
: Provisioned, Admitted and Active.
: The AdmittedQoSParaSet means that the set is only admitted but
: not activated by the BS. On the contrally, the ActiveQoSParaSet
: shall be admitted first(not for Provisioned), then the set can be
: activated. Therefore, in your context, the situation that
: ActiveQoSParaSet is set to zero means this parameter set is only
: admitted.
: Hope the above is helpful for you!
--
※ 发信站: 批踢踢实业坊(ptt.cc)
◆ From: 140.138.238.95